Maximize your cleaning experience by following the instructions listed below.
Pre-Wash: Soap to Water Ratio
The Off-Road Wash formula is a super concentrate and must be diluted prior to use. Mixing ratios can vary depending on applications and mud types. We highly recommend applying the product using our foam gun for garden hose or pressure washer. If you do not have a foam gun, you may also use a garden pump sprayer.
1 Gallon Garden Sprayer
Mix 8oz. with 1 Gallon of water and apply. Unused product may be stored in safe place for future washes.
Garden Hose Foam Gun
Add 8oz. to the tank and fill remaining space with water. Set at “0” or adjust for more water and less foam.
Pressure Washer Foam Gun
Add 8oz. to the tank and fill remaining space with water. Turn dial completely to right or adjust for less foam.
Step 1: Overall Wash
Before application, scrape off areas with extra thick mud or pre-rinse with water. Using your pre-mixed Off-Road Wash, fully saturate dirty and muddy surfaces. Allow product to soak for 3-5 minutes without drying up. Keep the surface moist by misting with water. For best results agitate with a scrub brush.
Step 2: Spot Clean and Rinse
While the Off-road Wash is soaking, use the Multi-Purpose Cleaner & Degreaser to target greasy spots and areas with nasty grime or film residue. Apply as needed and agitate with a scrub brush. Completely rinse the entire vehicle. (For best results, rinse using a pressurized nozzle on garden hose or a pressure washer.)
Step 3: Shine and Protect
Use a microfiber towel to wipe down and dry all the surfaces. Apply the Multi-Surface Shine & Protectant to plastic, rubber, and vinyl surfaces. Hold can approximately 5-8 inches away, spray an even layer to coat the surfaces. Buff with a towel for rich look or leave thick for a shiny coat. (Do not apply to tire treads, seat, or areas that should not become slippery.)